allows you to either enable or disable the primary/secondary controller. You might choose
to disable the controller if you were to add higher performance or specialized controller.
USB Keyboard Support
Enabled will support USB keyboard in Win95 2.1 and NT 5.0 or
above operating system.
Init Display First
This item will activate the PCI in the multi-displayed environment.
Power On Function
KB Power On Password:
this function is available for ATX power only. User can
select the power on method to power on the system. The options are the following
Password : when user select this option, it will show “Enter Password:”, after user type
password, it will show “Confirm Password:”, user should type the same password to
confirm it. After power off, if user types the correct password, the system will power on.
Hot Key :
when user select this option, it will show another line as “Hot Key Power
ON: Ctrl-F1”.Select any hot key you like. After power off, if user hold down the
“Control” and “F1” key, it will power up the system.
Mouse Left, Mouse Right :
it will power up the system by double clicking the left or
right mouse. Note do not move your mouse between the first click and the second click.
Button Only :
only the power button can power the system.
KBC input clock
Let user change the keyboard working clock.
On Board FDC Controller
This item will enable or disable the floppy disk controller.
On Board Serial Port 1
User can select serial port IRQ. If set to Auto, system will assign
an IRQ for it. Note : set to Auto is not recommended.
On Board Serial Port 2
User can select serial port IRQ. If set to Auto, system will assign
an IRQ for it. Note : set to Auto is not recommended.
UART Mode Select
This lets you select the Infrared mode. Choices are Standard, HPIR,
and ASKIR. If you choose HPIR or ASKIR mode, the screen will show another two lines
to let you choose ‘IR Function Duplex’ (Full or Half) and ‘RxD TxD Active’ (Hi Lo; Lo
Hi; Hi Hi; Lo Lo).
On Board Parallel Port
Let user select IRQ for parallel port When Disabled, the parallel
port will be disabled.
On Board Parallel Mode
Let user select error check mode. This item is not
recommended to change except user has special request.
ECP Mode Use DMA
Select a DMA channel for the port. Choices are 3, 1.
3