9
1
2
3
4
a
djustment
of
Bowl
fIxInG
:
The bowl arms must be raised to normal working posi-
tion. Loosen the counter nuts
(1) (fig. 5)
and remove the
cotterpins
(2)
. Turn the bolts
(3)
until correct fixing of the
bowl is achieved. By turning the bolts
out
of the extension
tube the fixing is increased. Start by turning one of the
bolts half a revolution.
The adjusting diameter shall be measured inside be-
tween the bowl arms
(fig. 5)
:
Adjusting diameter Y
:
a
djustment
of
Bowl
CenterInG
:
Loosen the counter nuts
(1)
(fig. 5)
and remove the cotter
pins
(2)
. Turn the bolts
(3)
until the bowl is in the centre of
the mixer. In order not to alter the fixing of the bowl, one of
the bolts must be turned
out
of the extension tube and the
other
into
the extension tube. Use the flat beater to check
that the bowl is correctly centred and turn the planetary
head with your hand before the voltage is connected.
m
easurInG
of
Bowl
heIGht
:
The distance
(X)
is measured from the bottom side of the
bayonet hole to the surface on the bowl arms on which
the bowl rests
(fig. 6).
The bowl arms must be lifted to
normal working position.
a
djustment
of
Bowl
heIGht
:
The upper and lower position of the bowl is determined
by micro switch
(1)
and
(2)
,
(fig. 6a)
.
The two mechanical stops consisting of the bolts
(3)
and
(4)
are adjusted so that they will be hit approx. 1 mm
after the micro switch, in case the micro switch should
fail. The upper position of the bowl arms is adjusted by
bending the spring arm on the micro switch
(1)
forwards
or backwards ,
It is of utmost importance that the stop screw
(3)
is re-
adjusted afterwards. In the same way the lower position
is adjusted by altering the micro switch
(2).
It is important
that the micro switch is not altered so much that the bowl
arms can not hit it.
Thereafter the mechanical stop
(4)
is adjusted.
fig. 5
Adjustment of bowl fixing and bowl centering
AR30
= 361,8mm
AR40
= 391,3mm
AR60
= 450,4mm
fig.6
Measuring of bowl height X:
fig.6a
Adjustment of bowl height:
AR30
=
162 mm.
Bowl height (X):
AR40
=162 mm.
AR60
=178 mm
Adjusting diameter Y
