A.O. Smith LOTUS-75TC, User Manual

Page: 15 / 54

ENG 13
the membrane shell. Doing so may cause permanent damage to the
membrane shell or membrane components (the membrane
manufacturer does not assume responsibility for returned components
due to damages incurred during installation).
• Damage to the membrane shell and reverse osmosis membrane
components inflicted as a result of the abovementioned reasons is not
covered under the water purifier’s warranty.
Installation Notes
• When installing the water pipes, you should not install a drain stopper.
Furthermore, the screw nut on the water pipe bottom connector should
have no wire teeth exposed.
• If the inlet water pipe is 9mm, you should ensure that the inlet water
pipe and connector have 30-40cm of straight piping to avoid pipe
bursting accidents caused by bending of the pipe.
• If the power cord wiring needs to be longer, extend the cord according
to the wiring requirements and use an 8mm pinched tube to wrap
around the connection. Later, wrap insulating electrical tape
on the outside surface. Do not place the cord on the floor. The cord
should be suspended in the air or should follow a path above ground.
• During installation, make sure that there is no electrical wiring or water
pipes embedded inside the walls where you will do the drilling.
Right way to cut pipes Wrong way to cut pipes
Diagram 10
Diagram 13
Diagram 11
Diagram 12
Clip (Before installation) Clip (After installation)