12
Figure 14
Switch on the water heater’s power supply.
The Power indicator lamp glows.
Temperature Setting
Turn the Temperature control knob clockwise
for the device to commence heating and
change the set temperature. The Heating
indicator lamp will glow. [The set temperature
increases if the Temperature control knob is
turned clockwise.] Temperature can be set in
the range of 25°C to 75°C. Recommended to
keep Temperature control knob notch position
always in medium or above level.
Heating
indicator
lamp
Power
indicator
lamp
When the temperature of the water drops by 5°C from the set temperature due to usage of
water, the water heater again enters into the heating mode.
Figure 15
Heating mode
Standby mode
When the actual temperature of the water
is less than the set temperature, it enters
into Heating mode. The Heating indicator
lamp glows as shown in (Fig. 15).
After the water heater reaches set temperature,
it will enter into the Standby mode due to
thermostat cut-off and the Power indicator
lamp glows and Heating indicator lamp switch
off as shown in (Fig. 16).
Figure 16
Temperature Control Knob
Modes
There are two types of modes depending on
the actual water temperature inside the inner
tank of the water heater:
Summary of Contents for HSE-SDS 6
Page 23: ......