5
MAX
MAX function means more hot water output, therefore, better bath experience.
.
Program
Program is to set up clock, and timing for heating. Two timers is available.
Hot Water Amount Display
Five light blocks visibly indicate the hot water amount available in tank.
Power-off Memory
By power-on more than 4 hours, the water heater could keep setting information for 72 hours when
power supply is cut-off.
Glass - lined Protection Tank
.
Anode Protection
High Efficiency Energy-saving Insulation
A polyurethane foam insulating layer without Freon reduces heat loss effectively.
Caution:
.
Installation Instructions
Caution:
The initial power on should be over 30 minutes after installation.
Mounting
The Glass-lined protection tank is a patent by A.O.Smith, coating tank with Silicide smoothly and
fusion at 870
℃
. The anti-rust and anti-scaling glass coating has pass 100,000 cycles fatigue life test
in accordance with relevant UL Standards.
A powerful steel-core-anode rod is used to protect tank and greatly prolong service life of the heat
pump water heater.
Hot water over 50
℃
has the risk of causing scald. Please do take care of your
family when settingtemp over 50
℃
.
2 or more staffs are needed to move or install the heat pump water heater due to the heavy
weight.
Plastic components on both left and right side can not afford overexertion, please take good
care. Neither tiling over 45° angle nor vertical placing is permitted.Disassembly and assembly
by users or unauthorized personnel are prohibited.
The heat pump water heater should be installed at a location that is close to power source, floor drain
and water utilization point. The heater should not be installed in places filled with fumes, strong
electromagnetic waves, high fluctuations of power voltage, acid or alkaline vapor. The air inlet of the
heat pump system
