12
Figure 17
Figure 18
Switch on the water heater’s power supply. The Power indicator lamp glows.
Temperaute Conrol Knob
Right Hand Side Inlet Outlet Models
(For HSE-HAS 15 and HSE-HAS 25 models)
Left Hand Side Inlet Outlet Models (For
HSE-HAS 15-LHS and HSE-HAS 25-LHS models)
RHS
LHS
When the temperature of the water drops by 5°C from the set temperature due to usage of
water, the water heater again enters into the Heating mode.
Temperature setting
Turn the Temperature control knob clockwise for the device to commence heating and change
the set temperature. The Heating indicator lamp will glow. [The set temperature increases if
the Temperature control knob is turned clockwise]. Temperature can be adjusted from 25°C to
maximum 75°C. Recommended to keep Temperature control knob notch position always in
medium or above level.
Modes
There are two types of modes depending on the actual water temperature inside the inner
tank of the water heater:
Figure 19
Heating mode
Standby mode
When the actual temperature of the water
is less than the set temperature, it enters
into Heating mode. The Heating indicator
lamp glows as shown in (Fig. 19)
After the water heater reaches set temperature,
it will enter into the Standby mode due to the
thermostat cut-off and the Power indicator lamp
glows and Heating indicator lamp switch off as
shown in (Fig. 20)
Figure 20
RHS
LHS
Heating
indicator
lamp
Power
indicator
lamp
RHS
LHS
Heating
indicator
lamp
Power
indicator
lamp
Summary of Contents for HAS
Page 23: ......
