Installation
Mounting
1. Make sure that the wall can withstand at least twice the weight of water heater when
completely filled with water.
2. Use a drill bit with diameter of 6mm to drill 3 holes at least 35mm deep in the wall, as
shown in the above diagram.
3. Insert the expansion anchors into the holes, tighten the screws providing sufficient gap for
mounting the water heater.
4. Hang the water heater using the 3 screws on the wall and ensure the water heater is fixed
steadily.
EWS 3 Litre
54.5 mm
116 mm
EWS 1 Litre
65mm
173mm
Water heater must be mounted on the wall by fixing 3 nos. of screws (as provided)
Plumbing
1. Make necessary plumbing with reference to the above installation diagram.
2. It is recommended that suitable nylon/SS braided hoses should be used. These hoses
should have a minimum pressure rating of 6.5 Bar and should be compatible for hot water
applications.
3. Connect the cold water pipe to the inlet [blue].
4. Connect the hot water pipe to the outlet [red].
Attention:
Make sure a suitable sealing tape is used for all water connections to prevent
leakage. Meanwhile, the hoses should not be tightened excessively over the inlet/outlet
tubes of the product. The hexagonal faces of the inlet outlet tubes must be held firmly by
means of a suitable wrench while fastening the hoses onto them. Failure to do so will
result in damages to the product and voids the guarantee.
3
