305, 505, 705 Indoor Manual
31
Remote
Controller
Installation
•
The controller should be out of reach of small
children.
•
Avoid locations where the controller may become
hot (near the oven or radiant heater).
•
Avoid locations in direct sunlight. The digital
display may be difficult to read in direct sunlight.
•
Avoid locations where the remote controller could
be splashed with liquids.
•
Do not install in locations where it can be adjusted
by the public.
Configurations
Cable Lengths and Size
The cable for the remote controller should be a non-
polarized two-core cable with a minimum gauge of 22
AWG. The maximum cable length from each
controller to the water heater depends on the total
number of wired controllers connected to the water
heater.
Number of Wired
Controllers
Maximum Cable Length for each
Controller to Water Heater
1
328 ft (100 m)
2
164 ft (50 m)
3 or 4
65 ft (20 m)
Location
Controllers
Wire controllers in parallel
Water
Heater
A maximum of 4 remote controllers can be installed for
a water heater or bank of water heaters. Controllers
can only be wired in parallel. Controllers cannot be
wired in series.
If 4 remote controllers are installed, simultaneously
press the Priority and On/Off buttons on the fourth
controller until a beep sounds.
Summary of Contents for 505
Page 40: ......