11
M757-1 Operating Juggler 2 Pixel Processor : User Guide
© 2023 7thSense
Rear Panel Connections
Debug features are for systems support only.
System I/O Module
This panel contains the unit's RJ45 network connection, four GPIO connectors, and the firmware SD
card. GPIO 1 is used for receiving tri-level sync signals. All other ports are configuration and debug
purposes only.
Note
that Compere software and Juggler-specific firmware can be updated via the Compere UI. The
SD card will never normally be required to be accessed.
Connecting External Equipment
To ensure best performance from the Juggler 2 and compliance with relevant EMC regulations, this
equipment should only be used with high-quality shielded data and signal cables.
Only equipment and accessories approved to IEC 60950-1 and SELV circuits may be connected to the
unit. All equipment and accessories shall comply to the relevant standard for the port or ports to
which it is connected.
Summary of Contents for Juggler 2
Page 1: ...Pixel Processing Operating Juggler 2 Pixel Processor M757 1 User Guide...
Page 25: ......
Page 26: ......
Page 27: ......