17
18
Note for
water washing
• Disconnect the power supply of the E-bike before cleaning. Do not touch the
live parts with wet hands or metal conductors, such as battery charging/
discharging port;
• Do not rinse the electrical components with water, but wipe the E-bike
appearance with a wet towel after drying it;
• Avoid rinsing the charging socket, wiring harness connectors and fuses
with water. Do not directly splash water on the storage box;
• Do not splash water directly on the brake, motor and front and rear axles
to prevent water from affecting the service life of the E-bike components;
• Do not wash the E-bike with steam or high pressure water.
Usage and Maintenance of Controller
• Regularly check whether the fixing screws and wiring of the controller are loose.
• Regularly clean the dust on the controller surface, which is conducive to heat dissipation. It is forbidden to
wash the electrical components with water to avoid the danger of electrical short-circuit fault;
• It is strictly forbidden to modify the controller circuit without permission;
• Regularly check controller wiring and fuses, etc;
• In case of any abnormality in the controller, stop running immediately and send it to the Infanti dealer or
after-sales service for inspection and maintenance.
Motor installation and maintenance
• Regularly check whether the end cap screws on both sides of the motor are loose.
• Regularly check whether the motor wiring is loose, whether the appearance is deformed, and whether the
motor phase wire is damaged.
• For use in rainy days, the motor cannot be driven in deep water, and the water surface cannot exceed the
position of the rear axle.
• The hub of the motor cannot be violently impacted, the motor cannot be forced to run under the condition
of locked rotor, and overloading of the motor is strictly prohibited.
• If the motor is found to be running abnormally, stop the movement immediately, and check and repair it in
the Invanti dealer or after-sales point.
12. Use & Maintenance of Controller and Motor
Check the chain
Loosen the rear axle nut first, and then turn left or right to adjust the chain drawing nut to correct the
slack of the chain. When adjusting the chain, align the front and rear sprockets to form a straight line.
After adjustment, re-fix the rear axle nut and lock the drawing nut to make the upper and lower
movable distance of the loose side of the chain at the midpoint of the two sprockets reach
10mm - 15mm.
10-15mm
