PRO-150 V1.0 11/18
Page 4
www.4qd.co.uk
4. Mounting
The dimensions of the Pro-150's base plate are shown below. It has two M5 tapped
screw holes for mounting: ideally it should be in thermal contact with the machine's
chassis which will then act as additional heatsinking.
The Pro-150 may be mounted in any orientation. However you should consider
whether it is likely to be subject to dust, dirt, oil or water during use and mount it
appropriately.
The best orientation is vertically with connections at the bottom: this way if water
splashes get onto leads etc. they will simply run downwards away from the Pro-
150. Otherwise mount with the heatsink at the bottom so water cannot get onto the
circuit board.
Allow plenty of space to install the Pro-150 and all connecting wires, and mount so
that the mounting screws can be easily accessed.
