4PRO 4PROCN55, Original Instructions Manual

Page: 26 / 34

SAFETY INSTRUCTIONS
24. GENERAL PRECAUTIONS IN ADDITION TO WARNINGS IN THIS MANUAL:
- Do not use tool as a hammer.
- Always carry the tool by the grip, never carry the tool by air hose.
- Do not expose tool and the compressor to the sunshine for longer period of time. Keep the tool
in a dry place our of reach of children when not in use.
- Do not use the tool without warning labels.
- Tool must be used only for the purpose it was designed.
- Never remove, tamper with the operating controls (e.g. trigger, contact arm).
- Stands for mounting the fasteners driving tools to a support for example a work table, shall be
designed and constructed by the stand manufacturer in such a way that the fastener driving tool
can be safely fixed for the intended use, thus for example avoiding damage, distortion or
displacement.
Employer's Responsibilities
1. Ensure that this manual is available to operators and personnel performing maintenance.
2. Ensure that nailers are used only when operators and others in work area are wearing EYE
PROTECTION.
3. Keep nailer in safe working order.
4. Maintain nailer properly.
NAILER CONNECTION AND OPERATION
NOTE: The information contained in this manual is designed to assist you in the safe operation of
the nailer. Some illustrations in this Manual may show details or attachments that are different
from those on your nailer.
Air Supply, Connections and Operating Pressure
Read section titled SAFETY INSTRUCTIONS before operating the tool. Make sure of the following
before operation:
WARNING! DO NOT CONNECT OR DISCONNECT TOOL FROM AIR SUPPLY WHEN ANY
ONE OF THE OPERATING CONTROLS (TRIGGER, CONTACT ARM) IS ACTIVATED. DO
POINT THE DISCHARGE OUTLET TOWARD YOURSELF AND PERSONNEL. Before connecting
tool to air supply empty the magazine.
Air Supply
Power Source (Compressor)
- Use only clean, dry, regulated compressed air as a power source for this nailer.
- NEVER use oxygen, combustible gasses or other bottled gases, as an explosion may occur.
- Moisture in the air compressor may accelerate wear and tool corrosion.
- Drain daily.
.
25
cut-off valve