Then check that volume is at 100% throughout. Stop the audio file, reset it back to the start, and tap
Reverse A
button to reset. The
Hold A
button should light up. Play the file from the beginning again.
Factory Reset after Update (recommended)
Because Version 5 makes very extensive changes in the operation of the DLD firmware, we recommend that
you execute the
Factory Reset
procedure following the update.
Take care to note any
System Settings
that you care about, as the
Reset
procedure will return all settings to
their factory defaults.
To perform a factory reset:
1. Unplug all cables.
2. Power off the DLD.
3.
Flip
Time A
down,
Time B
up.
4.
Hold down
Infinite A
,
Infinite B
, and
Reverse B.
5.
Power the DLD on. Release the buttons, the four
Reverse/Infinite
buttons will flash.
6.
Now, flip
Time A
up,
Time B
down.
7.
Hold down all five buttons (
Rev A, Inf A, Rev B, Inf B, Ping
) for 10 seconds.
8. Release the buttons when you see the lights make a chase sequence.
9. Power off, and power back on.
The DLD has now been reset to its factory default settings.
New Features and Enhancements
New Feature!
High Resolution Audio: 24-bit Audio Operation
The DLD can now operate with superb full
24-bit
audio by installing a jumper on the back of the module in the
position 2 shown in the photo makes it run in
24-bit
mode. The jumper goes on the 2x6 header (labeled P9 in tiny
lettering). (Jumper position 1 is the left-most jumper, closest to the BUS CLK jumpers Jumper position 2 is the next
one to the right.)
When the jumper is on, the DLD will power up with a tap tempo pre-set to half the speed than if the jumper is off,
indicating the new hi-resolution mode. Audio delay capacity in 24-bit mode is one-half that of 16-bit mode. Sample
rate in all modes is 48 kHz.
