7. Slide the movement
joint
(L) underneath the clips at the back edge of the front body as shown. Push a long peg
(J
- with " + "
embossed) through the movement
joint's
round hole and the back hinge connector. Then insert the medium peg (K - with " - "
embossed) through the movement joint's long slot and into the hole of the front body's round joint.
8.
Insert the battery case holder (C) into the slots on the back hinges with the round screw hole facing upwards. Slide the front bodyˇs
black and red wires underneath the battery case and movement joint connector to prepare for step 10.
9.
Make sure the robot is in off mode before inserting the 2 x 1.5V AAA batteries into the battery case (S) and secure the battery case
cover (T) over top. Secure the battery case to the battery case holder afterwards as shown.
10. Insert the black wires into the back bodyˇs left metal hole and secure them in place with a short peg. Repeat this process with the red
wires in the other metal hole.
11. Attach one of the shells (R) to the two
joints
on the left front hinge. Repeat with the other shell on the right side and then
join
the
shells together with the small
holes/joints
at the top of the shell edges. Stick the googly eyes
(W)
onto the left/right eyes (M & N) and
insert them into the holes on the top of the front body as shown.
12. Peel off the plastic film on each foam foot
(X)
before sticking them onto the feet at the bottom of the front and back body.
Your
robot
is now complete!
D. ASSEMBLY
1. Insert the motor
(Q)
into the slots inside the front body top (P) as shown. Insert the wires into the small side and end slots so the front
body base, secured in step 3, does not cut the wire.
2. Insert the gear axle (U) into the hole beside the main gear. Then place the small gear (V) on top with the flat side facing up.
3. Fit the gear
joint
holder's
(B) joints
into the raised slots on either side of the main gear as shown. Cover the gears and motor with the
front body base (E) and secure it in place with three small screws
(Y).
Make sure the vertical flap of the movement
joint
holder slides
through the square hole at the back of the front body base.
4. Attach the left back hinge (G) (the hinge with a small notch at the side to differentiate) to the left side of the back body base (O) with a
short peg (I). Attach the right back hinge (H) to the right side of the back body base with another short peg. Then insert the back hinge
connector (D) into the two slanted slots with the flat side facing up.
5. Flip the front body over and attach the two front hinges (F) to the front body top with two short pegs as shown. The two protruding
joints
on each front hinge should face outwards. Finally, insert the front hinge connector (A) into the slots on the inside of each front
hinge.
6. Connect the front hinges to the back hinges with two short pegs.
1.5 V
AAA
-
+
1.5 V
AAA
-
+
P
Q
B
O
H
G
F
F
D
C
A
T
S
W
U
I
V
X
Y
E
R
R
1
2
7
9
10
11
12
8
3
4
5
6
M
N
L
K
J
1.5 V
AAA
-
+
1.5 V
AAA
-
+
P
Q
B
O
H
G
F
F
D
C
A
T
S
W
U
I
V
X
Y
E
R
R
1
2
7
9
10
11
12
8
3
4
5
6
M
N
L
K
J
