Return out of control
When the remote control signal is interrupted for approximately 4 seconds, the drone will
automatically fly back to the location with the appropriate signal.
Return when the battery is low
If the battery is low, the drone will be forced to return to a position about 20 m above the take-
off point. The return cannot be cancelled during the return with low batteries.
12.3 Speed switching:
When the drone takes off, it flies in low speed mode by default (3 gears), press the
remote control lightly, "di" for low gear, "di di" for medium gear and "di di di" for high gear
(Figure 17).
APP operation: click on the "More settings" icon (Figure 18) in the APP control interface
to switch the drone flight speed (Figure 19).
Figure
17Figure
18Figure 19
12.4 Flight mode with waypoint
①
In GPS mode, click the "More Settings" icon (Figure 20) in the APP control interface
to enter the multi-site flight (Figure 21), then the interface will switch from the image
transmission page to the map page.
On the map page, click to set a route range consisting of a single waypoint or continuous
waypoints (Figure 22).
If there are too many waypoints during setup, you can click the Delete icon to remove all
waypoints (Figure 23).
②
After setting the waypoints, click the Send icon (Figure 24), the drone will
automatically fly to all waypoints from the starting point to complete the preset flight path.
You can control the direction of the drone during flight using the joystick.
Figure
20Figure
21Figure 22
Figure
23Figure 24
