PRODUCT OVERVIEW
The P300 is an inductive sensor designed to detect shaft speed, shaft position, gate position, or object
presence. No contact is made between the sensor and the object being monitored.
Maximum range of ferrous targets is 8 mm (5/16”) and for non-ferrous targets is 5 mm (6/16”), assuming a
20 mm (3/4”) diameter target. Smaller targets may be used but operating distances will be reduced.
Three
different sensor outputs are available.
P3003V10AI and P3004V10AI sensors have a two-wire interface and have an internal transistor which
either switches to open or closed state when target is present (see page 10). P3003V34AI has an isolated
transistor and the output is determined by the orientation of the positive and negative supply connections
(page 10).
All units are fully encapsulated and come with a 3m cable lead. Two LED’s show power supply and input
status.
SPECIFICATIONS
WARNING
• Rotating machinery can cause serious injury or death
• Always lockout and tagout the machine prior to installation
PAGE 6
Supply Voltage:
P3003V10AI and P3004V10AI: 24 - 240 VAC/VDC
P3003V34AI: 10-30VDC
Supply Fusing:
Supply to be fused at 500mA maximum. Note: fuse must be 1500A capable.
1 fuse per sensor
MUST
be used.
Switching Capacity:
P3003V10AI and P3004V10AI: 100 mA maximum
P3003V34AI: Opto-isolated transistor, 30VDC, 100mA max
Saturation Voltage:
P3003V10AI and P3004V10AI: 5.5 Volts maximum (output on)
P3003V34AI: N/A
Leakage Current:
P3003V10AI and P3004V10AI: 1.0 mA maximum (output off)
P3003V34AI: N/A
Ambient Temperature:
-13°F (-25°C) to +122°F (+50°C)
Output State:
See page 10
Sensing Range:
8 mm (5/16”) maximum on ferrous metal at 77°F (25°C)
5 mm (6/16”) maximum on non-ferrous metal at 77°F (25°C)
Input Pulse Range:
10 to 3,600 pulses per minute (PPM) maximum
Enclosure:
Nylon - ISO threaded 30 mm by 1.5 mm pitch
Relative Humidity:
90% RH
LED Indicators:
Red - Target Sensed
Connections:
2 wire (P3003V10AI, P3004V10AI)
4 wire (P3003V34AI)
Cable Length - 3m
Protection:
IP66
