4B IE-NODE 2, Operation Manual

Page: 21 / 28

PAGE 21
If you are using an expansion card with a Modbus RTU connection, you can update the Modbus RTU ID
of the IE-NODE by selecting “Change ETH-NODE X Modbus ID ” from the main menu (Image 6).
You can interrogate the device for its current ID by selecting “Read ID”. You can also enter a new
ID and update the ID of the IE-NODE by selecting “Update ID”. Note that this ID will only be used
if dipswitch 8 is in the ON (Right) position. Otherwise, the rotary switch will override the address in
memory.
Unless instructed by 4B, do not use “
Update IE-NODE Main/Auxiliary Firmware” or “ Update DIGI Module
via FTP ” from the IE-NODE’s Configurator Menu (Image 6) as these options are used for firmware
updates.
For any questions regarding using the network configuration software or any network settings, contact
4B.
Image 11 -
Update Node ID