493K K-METRON, User Instructions, Page: 21 / 29

K-METRON Radio User Instructions (Firmware 3.0.4; Doc v4.0)
20 | P a g e
To assign the COM number withing the K-METRON software:
•
Run K-METRON Software
•
Go to options and assign the correct COM Port.
8.4 Start Recording
Click on the Start button within the K-METRON software. Provided the COM port is set up
correctly and the receiver is communicating with the PC the Status will be shown as
Waiting
for data…
Once the transmission between the handheld unit and the receiver is sent by pulling the
orange trigger the Status will change to
Re cording… and the Position number should
increment to “001” and the reading displayed as measured. If the Status remains as Waiting
for data… , even after the orange trigger has been pulled then check that the transmitter
and receiver are within radio range and also ensure that the transmitter radio is operational,
(i.e. not turned off in the Configuration Menu).