14
INSTALLATION AWNING MOTOR
1
Preparation:
•
Screw in awning & secure with straps or ropes.
•
Remove awning from wall bracket & place on safe surface.
2
Prepare motor for installation:
•
Slide limit switch adapter flush against motor head.
>
fig. 2.1 / 2.2
•
Secure the shaft adapter with the supplied securing bracket.
>
fig. 2.3 / 2.4
3
Installation awning motor:
•
Remove the cover to access the side bearing (also awning bracket)
and fastening screws.
>
fig. 3.1
•
Loosen the screw that secures the side bearing to the support tube.
>
fig. 3.2
•
Remove all screws connecting the side bearing
and the crank mechanism.
>
fig. 3.3
•
Remove the side bearing from the support tube.
>
fig. 3.4
•
Remove the crank mechanism.
>
fig. 3.5
Attention:
Awning arms are under strong tension!
2.1
Limit switch adapter
Motor head
2.2
2.3
Securing bracket
2.4
Click
Shaft adapter
Side bearing
Cover
3.1
Support tube
Side bearing
3.2
3.2
3.4
Crank mechanism
•
Remove the shaft capsule from the shaft.
>
fig. 3.6
If the shaft capsule is tight, use a hammer and screwdriver.
Be careful not to damage the shaft.
•
Push the awning motor with shaft adapter first into the shaft.
>
fig. 3.7
•
Make sure motor head & limit switch adapter are flush in shaft.
•
Screw the universal bearing onto the side bearing on the side
facing the awning shaft.
>
fig. 3.8
3.5
3.6
3.7
3.8
Support tube
Shaft capsule
Shaft &
wound up
Awning
Universal
bearing
Shaft &
wound up
Awning
INSTALLATION INSTRUCTIONS
3T-MOTORS Tubular motors
| Installation instructions
