![background image](http://html1.mh-extra.com/html/3svision/n1072/n1072_user-manual_3196512066.webp)
N1072
Box Network Camera
2 Meg H.264
- 66 -
PPPoE Setting (Dial-up Networking Setting)
Point-to-Point Protocol over Ethernet is a protocol that supports access to a high-speed
wideband network using a PC and a wideband modem (such as xDSL, Cable, Wireless
modem). The user need only to equip the PC with an Ethernet card and apply to an ISP
and an ADSL provider (such as Chunghwa Telecom) for ADSL service to roam the
Internet through ordinary twisted copper wires.
PPPoE setting must be executed in the LAN environment for your PC to connect to ADSL.
Follow the steps below to complete the setting:
1. Dial: You can select whether or not to dial when you boot the machine.
2. Use DHCP or fixed IP for connection to the LAN environment.
3. Key in the IP address of the camera and enter "PPPoE Setting" following the route
Setting
Basic Setting
Network
PPPoE.
4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click
Save
to
confirm the setting.
5. Where the ADSL modem and the camera is connected via a switch-hub, you can
press “Reboot” or restart the machine manually to try PPPoE dialing when the setting
of the camera has been completed.
6. A different IP address is obtained after each dial-up network connection. You can get
the new IP address from Setting
Basic Settings
System. If you want to know the
new IP address anytime, you must enter Setting
Basic Settings
Notification to
set some settings. There are three ways to get information: 1. SMTP 2. FTP 3. HTTP.
For details, refer to the Notification Setup Menu.
NOTE
:
You can use the DDNS function to access the camera. Refer to the
DDNS Setting
for
more information
PPPoE
Dial:
You can select whether or not to dial when you boot the Camera.
(On boot or Off).
Username:
Enter the username provided by your ISP.
Password:
Enter the password.
PPPoE Information
IP Address:
The IP address is acquired when the dialing has been executed
successfully.
Subnet Mask:
The subnet mask information is acquired when the dialing has been
executed successfully.
Default Gateway: The gateway information is acquired when the dialing has been
executed successfully.
DNS:
The ISP domain name is acquired when the dialing has been
executed successfully.