This series of device provides 8
10/100Base-T(X) interfaces, the
interface type is M12 D-Coded
4-Pin slot (female). Single port
supports up to 30W PoE power
output, PoE power supply Pin 1
and 3 are positive, 2 and 4 are negative, and M12 pin is defined
as follows:
Pin No. Pin Definition Description
1
TD+
Positive send data of 100M
Ethernet
2
RD+
Positive receive data of
100M Ethernet
3
TD-
Negative send data of
100M Ethernet
4
RD-
Negative receive data of
100M Ethernet
Gigabit M12 interface
This series of device provides 4 10/100/1000Base-T(X)
interfaces, the interface type is M12 X-Coded 8-Pin slot
(female). Two groups of Bypass interfaces are supported, in
which G1 and G2 are a group and G3 and G4 are a group.
The pin definitions of M12 are shown as follows:
Pin No.
Pin Definition
Description
1
GE0+
Positive bi-directional
data of Gigabit Ethernet
group 1
Pin No.
Pin Definition
Description
2
GE0-
Negative bi-directional
data of Gigabit Ethernet
group 1
3
GE1+
Positive bi-directional
data of Gigabit Ethernet
group 2
4
GE1-
Negative bi-directional
data of Gigabit Ethernet
group 2
5
GE3+
Positive bi-directional
data of Gigabit Ethernet
group 4
6
GE3-
Negative bi-directional
data of Gigabit Ethernet
group 4
7
GE2-
Negative bi-directional
data of Gigabit Ethernet
group 3
8
GE2+
Positive bi-directional
data of Gigabit Ethernet
group 3
【
Checking LED Indicator
】
The series of devices provide LED indicators to monitor its
operating status, which has simplified the overall
troubleshooting process. The function of each LED is
described in the table below:
LED
Indicate Description
P1/P2
ON
P1/2 is connected and running
normally
OFF
P1/2 is disconnected and
running abnormally
ALM
ON
Port link has alarm
OFF
Port link has no alarm
RUN
ON
The device is powering on or
the device is abnormal.
OFF
The device is powered off or the
device is abnormal.
Blinking
Blinking 1 time per second,
system is running normally
LINK(E1-
E12, G1-
G12)
ON
Ethernet port has established a
valid network connection
Blinking
Ethernet port is in an active
network status
OFF
Ethernet port has not
established valid network
connection
POE(E1-
E8, G1-G8)
ON
POE port is powering other PD
devices normally
OFF
POE port is not powering other
PD devices
【
Logging in to WEB Interface
】
This series of devices supports WEB management and
configuration, and computers can access devices through
Ethernet interfaces. The way of logging in to device’s
configuration interface via IE browser is shown as below:
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed.
Enter device’s IP address in the address bar of the
computer browser.
Enter device’s username and password in the login
window as shown below.
