Shenzhen
3onedata Technology Co., Ltd
10
www.3onedata.com
Chapter 5 Overview of Product Configuration
CAN485 converter configuration, including converter conversion, serial port and CAN-Bus parameters etc...
Parameter configuration is done through special configuration software without hardware configuration. In normal
before use and need to pre configured CAN485 converter conversion parameters. If there is no configuration, then
CAN485 converter will use the default parameters.
5.1 Product configuration
In order to make the converter enter configuration mode, with a special configuration of the DIP switch that
RS-485 interface side of the DIP switch pin 2. Pin 2 is allocated to ON enable end, the converter enter
configuration mode. Pin 2 is allocated to number end, the converter power on into "normal operation" mode. Enter
the configuration steps are as follows:
1.
The converter switch pin 2 is allocated to the ON side, and then power on;
2.
Connecting the converter and the computer with serial line;
（
baud rate 19200bps
）
3.
Open the configuration software, connect the device, open the serial port, and set parameters.
5.2 Introduction of Software
(Figure 5.2)
CAN485 converter configuration software is included in the CD products. The interface of the software is shown in
figure 5.2. Set the software to memory and display parameters of the CAN485 converter the last successful set (if it
