2. Identifying serial number on the XT-1 Headset / G5 Headset Components:
Follow the procedure below to disassemble the G5 Headset to it’s individual components – The G5 Control Pod, the G5 Carrier
and the G5 Battery.
1. Remove the G5 battery from the G5 Headset
- Orient the headset in the position as shown in the illustration below.
- Position your thumb right under the latch and your index finger nail in the groove where the battery meets the headset.
- Now in one smooth motion and simultaneously push the battery latch up with your thumb while pulling the battery from the
housing with your index fingernail. This will release the battery.
- Using your finger nail, gently pull the discharged battery from the battery housing. Once dislodged, you may use your thumb
and remaining fingers to completely slide the battery out of the headset.
2. Separate the G5 Control Pod from the G5 Carrier
- On the opposite side of the G5 Headset Carrier, ensure that the G5 Control Pod Locking Mechanism is in the unlocked
position by sliding it all the way to the left. A small flat head screwdriver or other similar tool can be used to slide the locking
mechanism if needed.
- Insert your thumb into the battery cavity while securely holding on to the top of the G5 Carrier and gently separate the
G5 Control Pod from the G5 Carrier.
IMPORTANT NOTE:
Make sure you
DO NOT
hold the G5 Control Pod battery tab with your thumb to separate the Pod from
the Carrier. Failing to do so may result in breaking of the battery tab.
2
