Attach Fluid Hose Whip to base of spray gun.
2
1
Attach the supplied air flow valve to the bottom of the gun.
4
Connect hose whip to nozzle.
5
Attach fluid and pressure lines from bulk feed system (or pres-
sure pot)
Note: Utilize the optional manual fluid shut-off valve, if
desired, between hose whip and fluid supply
3
Attach the nozzle to the spray gun with the locking collar fully
connected.
Note: It is easier to install the nozzle while pulling
the trigger backward toward the spray gun handle.
Cleaning
1.1
1.4
1.8
Base Coat / Single Stage Materials
Release Agents
1K Top Coats
2K Top Coats
Clear Coats
Textured Paints
Epoxy / Urethanes Primers
Adhesives
VOLTAIRE 26
VOLTAIRE 28
VOLTAIRE 25
VOLTAIRE 27
© 3M 2020. All rights reserved. 3M, Accuspray and PPS are trademarks of 3M Company, used under license in Canada. 60-4550-8097-2, 34-8717-9095-1
Once the system is adequately flushed (pot, lines),
depressurize the system (or close the optional
fluid valve)
1
2
After pressure is relieved, remove the hose whip
from the nozzle.
4
Wipe needle tip. Store spray gun with a nozzle
attached to protect the needle.
3
Remove nozzle from spray gun to clean residue
from the nozzle. Rinse out and flush cleaning solvent
through the nozzle with fluid tip pointed straight
down into receptacle to collect waste solvent.
Pressure
Gravity
Once coating application is complete, disconnect
the air hose from the gun.
1
2
To drain back paint into cup - Invert cup, pull trigger,
and tap the PPS™ cup on a table 3 times.
4
Store spray gun with a nozzle attached to protect
the needle.
3
Rinse out nozzle spout and flush cleaning solvent
through the nozzle by pulling trigger with fluid tip
pointed straight down into receptacle to collect
waste solvent.
Nozzle Recommendation
*Starting points only, refer to Paint Manufacture for
recommendation on fluid tip size
Assembly
VOLTAIRE 14
VOLTAIRE 13
For additional questions, contact your local 3M representative
or:
1 877 MMM CARS (666-2277)
See manual for additional use and safety information.
WARNING!
Do not immerse spray gun or nozzles in cleaning
solvents or gun washers. The maximum operational air
pressure of this HVLP spray gun is 18 PSI.
3M™ Performance Spray Gun HVLP – Pressure
Maximum Operating Pressure: 18 psi | 1.24 bar
Recommended Set Up Starting Points
Fan Control Knob: Open 2 rotations from closed position
Fluid Control Knob: Open 4 rotations from closed position
Air Flow control valve: 18-20 psi / 1.24 – 1.37 Bar
