Adding the 3M
™
PPS
™
Series 2.0 Spray Cup
System Components
1
Insert the 3M
™
PPS
™
Series 2.0 Spray Cup System
disposable liner into the 3M
™
PPS
™
Series 2.0 Spray
Cup System mixing cup.
2
Pour material to be sprayed into the 3M
™
PPS
™
Series 2.0 Spray Cup System mixing cup. Stir
as needed.
3
Place the 3M
™
PPS
™
Series 2.0 Spray Cup System
lid with built-in filter on top of the 3M
™
PPS
™
mixing
cup with liner and snap into place.
4
Turn until tight. Insert 3M
™
PPS
™
Series 2.0 Spray
Cup System sealing plug prior to shaking or sealing.
5
Attach spray gun to filled 3M
™
PPS
™
Series 2.0
Spray Cup System cup.
Cleaning
1
Once coating application is complete, disconnect the air hose
from the gun.
2
To drain back paint into cup – invert cup, pull trigger, and tap
the 3M
™
PPS
™
Series 2.0 cup on a table 3 times.
3
Rinse out nozzle spout and flush cleaning solvent through the nozzle
by pulling trigger with fluid tip pointed straight down into receptacle
to collect waste solvent.
4
Store spray gun with a clean nozzle attached to protect the needle.
3M
™
Performance Spray Gun – Gravity
Operating Pressure Range* is between 7 psi - 37 psi (0.5 bar - 2.6 bar)
ATTENTION
Note: Do not put Spray Gun/Spray Gun Body in Gun Washer.
© 3M 2022. 3M and PPS are trademarks of 3M Company. All rights reserved.
For additional questions, contact your local 3M representative
or email: [email protected].
See manual for additional use and health and safety information.
