3M Peltor WS5, Instruction Manual

Page: 7 / 30

2 3
1. Quick Start Guide - Fig. A
1:1 Inserting the Batteries
A:1 Remove the left outer shell.
A:2 Insert a tool or finger under the edge of the
clamp and pull it out approximately 1/8 inch.
A:3 Press/slide the clamp down. Remove the shell.
Insert the rechargeable AAA NiMH batteries
included with the product.
1:2 Charging Your Headset
Connect the charger to the charger jack on the
headset. Charge the headset for 8 hours to achieve
the maximum battery capacity.
1:3 Switching the Headset On and Off
Press and hold the On/Off/Mode button for
two seconds to switch the headset on or off.
1:4 Bluetooth Pairing
The headset can be paired with and connected to
Bluetooth
®
units that support A2DP, HFP and HSP.
NOTE that you can only stream stereo sound/music from
a unit (mobile phone, computer, etc.) that supports the
A2DP Bluetooth
®
profile.
• Ensure that the headset is charged and switched off.
• Press and hold the On/Off/Mode button for five seconds.
This puts the headset into pairing mode, which is
confirmed by a voice repeating: “Bluetooth
®
pairing on”.
• Activate your telephone’s Bluetooth ® function and
search for new units. After a few seconds “Peltor WS5”
will appear on the screen.
• Select “Peltor WS5”.
• If the phone asks you for a password, enter: 0000
• Pairing is confirmed when the voice says:
“pairing complete”.
1:5 Managing phone calls
• Answering calls
Incoming phone calls are indicated with a ringtone
in the headset.
Answer by pressing briefly on the Bluetooth ® button.
• Rejecting a call
Reject a call by pressing and holding the Bluetooth ® button.
• Voice dial
Press briefly on the Bluetooth
®
button.
•
Redial
Press and hold the Bluetooth ® button for 2 seconds.
1:6 Adjusting surround-sound volume
Increase volume. Press the (upper) + button
Decrease volume. Press the (lower) – button
1:7 Adjusting call volume
Adjust volume during a call by pressing the (+) or (–) buttons.
Press briefly on the On/Off/Mode button and then (+) or (–)
to adjust the surround-sound volume during a call.
1:8 Adjusting streamed-music volume
Adjust volume while streaming music by pressing the (+) or (–) buttons. Press briefly
on the On/Off/Mode button and then (+) or (–) to adjust the surround-sound volume
during music streaming.
1:9 Changing settings in the Configure menu
Settings can be adjusted using the Configure menu. To access the menu, press and
hold the (–) and (+) buttons for 2 seconds (with the headset switched on).
Access to the Configure menu is confirmed by a voice saying:
“menu”. To change the
settings, use the (–) and (+) buttons. To move through the Configure menu, press briefly
on the On/Off/Mode button.
A:1
A:2
A:3
Bluetooth
+
On/Off/
Mode
_
Fig. A