3M
Multimedia Projector MP8620
Adjustments
3M 1999
1-6
1-7-3.
LCD Ribbon Cable Installation
Installing a new LCD ribbon cable is done using the following steps:
1.
Gently pull out the white plastic clamp on the LCD and Interface board connectors to release the LCD
ribbon cable.
2.
Insert one end of the new ribbon cable into the LCD connector. The blue side of the cable should be facing
up.
3.
Insert the other end of the new ribbon cable into the interface board connector. The blue side of the cable
should be facing down.
4.
Lock the white plastic clamps into place on both the LCD connector and the Interface board connector.
5.
Use the old cable as a pattern to place the appropriate bends in the new cable.
If a connector clamp is broken:
Order a complete connector (DY-0205-1512-7).
Remove the plastic portion from the new connector and replace the broken part.
If the connector can not be repaired in this way, the LCD or interface board may need to be replaced.
