Downloaded from Projector.com
10
3M
Multimedia Projector MP8610
3M 1998
Section 5: Remote Control
5-1. How to Operate the Remote Control
The remote control keypad (Figure 5–3) controls basic projector functions. To use the remote control,
aim the remote toward the projection screen and press the desired button. The remote signal (Figure 5-1)
will bounce off of the projection screen and back to the sensor on the front of the projector.
Figure 5-1. Remote Control Signal
5-2. Replacing the Batteries
The remote control uses two AAA batteries. The battery cover is located on the back of the remote
control (Figure 5-3).
1.
Press the locking tab (1) to release the battery compartment door.
2.
Lift up on the door (2) to remove it and set it to the side.
3.
Remove old batteries.
4.
Install new batteries (3) making sure the polarity (+/-) on each battery matches the decal in the
battery compartment.
5.
Replace battery compartment door.
Figure 5-2. Replacing Batteries
MP8610
8610-12A
+
–
+
–
8610-06A
+
–
+
–
1
2
3
