Model C1060
Maintenance
3M 2001 February
13
When the battery voltage is too low, the headset sounds a short, low–volume
tone at seven–second intervals to alert the operator to install a fully charged
battery. The “ low battery tone” continues for two minutes after which the
headset turns off automatically to prevent damage to the batteries.
ü
Note
When installing a battery, make sure it is fully charged. It is important to
remember that an unused C1060 battery loses five percent of its charge per
week. If a battery has not been used for several weeks, make sure to charge
prior to use.
To replace the battery:
1. Slide and hold the battery release. See Figure 11.
2. Remove the discharged battery from the battery housing.
3.
Insert a fully charged battery in the housing with the notch facing the
battery release. Make sure the battery is fully inserted (battery release
clicks). See Figure 11.
Figure 11.
Headset
Replacing the Battery