4. Install Vehicle Detector Board and any External Antennas.
Installing Vehicle Detector Boards
G5 Basestation accommodates up to TWO vehicle detector boards and these MUST be connected to the Order Point induction loops.
Follow the procedure below to install them into the G5 basestation.
Align the bottom of the vehicle detector board with
the installation slot.
Slide the top edge of the board between the back
of the base station and the two raised tabs.
Install and gently tighten the screw.
Carefully install the three wires between the
vehicle detector board and the base station board.
The left-to-right pin order is the same on both boards:
the left pin on one corresponds to the left pin on the other.
Configure the dip switches, if required, according to the table on the circuit board and your needs .
Lane 1
Lane 2
Dip Switch Settings
Installing External Antenna(s)
If the store currently uses an External Antenna (either Omni-Directional or Patch Antenna), it is assumed that the location of the external
antenna is not going to change.
Follow the steps below to re-connect the existing external antenna.
Remove either the left or right antenna on
the G5 Basestation
Connect the pigtail to basestation antenna connector,
in spot where antenna was removed
NOTE: DO NOT use a tool to tighten the pigtail to
the Base Station, leave the connection finger tight.
Connect coaxial cable (of the external antenna) to pigtail.
G5 Basestation Antenna
6
