3M Digital Media Systems 800 Series, Operator And Product Safety Manual

Page: 16 / 240

16
M
™
Digital Media System 800 Series
© M 2006. All Rights Reserved.
E
N
G
L
IS
H
Basic Operations
Basic Operations
Projector Start Up
Read the Safety Information before operating the Digital Media System 800. After all cable connections have
been completed, the projector can be powered up.
1. Turn off all power to the projector and input sources during cable hook up.
2. Connect cables being careful not to bend any pins in the cable plug or input terminal.
. Press the Main Power switch on the control Panel to ON. A red LED indicator will illuminate to indicate
there is power.
4. Press the Standby button on Remote Control to illuminate the lamp. A red LED indicator will turn green as
an image appears and grows brighter on the screen.
5. Adjust Zoom button on Remote Control for best image.
6. Power up your computer and video source(s).
Stand By Mode
When the projector is not being used, place it into standby mode.
1. Press the Standby button on Remote Control.
2. The lamp will switch off and the red LED will illuminate.
Note: The fan motor will continue to run for a few minutes until the projector cools down and then the fan
will turn off.
. Press the Standby button on Remote Control again to illuminate the lamp and project an image on the
screen.
Projector Power Down
1. Press the Standby button on controller to place the projector in the standby mode (red LED illuminates).
2. Wait until the cooling fan cycles off and the LEDs turn off.
Note: Switching the main power off before the fan has cycled off will decrease the life of the projection lamp.
. Press the Main Power switch on Control Panel to Off.
4. Turn off the power of your input devices.
E
N
G
L
IS
H