3M DB565, Product Safety Manual

Page: 6 / 42

6
Introduction
3M™ Digital Board
© 3M 006. All Rights Reserved.
E
N
G
L
IS
H
m WARNING
To reduce the risk associated with the various hazards related to the 3M Digital Board:
•
Please read, understand and follow all safety information contained in this installation manual prior to the
installation and use.
To reduce the risk associated with impact:
•
Always provide proper adult supervision when using the 3M Digital Board around children.
• Always place the 3M Digital Board on a stable and level surface.
• Install the 3M Digital Board on a wall with 1/-inch-thick drywall minimum.
• Use only 3M recommended wall mounting hardware.
• Follow all installation instructions carefully.
• Make sure mounting screws are properly sized to handle the weight of the 3M Digital Board.
• Make sure mounting hardware is securely anchored to a solid structure.
• Proper installation must be performed by qualified service technicians, as outlined in the installation
instructions. Failure to do so could result in serious injury and/or damage to the 3M Digital Board.
• At least two qualified service technicians should perform the installation procedure. Serious personal injury
and/or damage can result from dropping the 3M Digital Board
To reduce the risk associated with choking:
• Keep batteries away from children and pets.
m CAUTION
To reduce the risk associated with environmental contamination:
•
Dispose of 3M™ Digital Board components in accordance with applicable federal, state, and local
regulations.
To reduce the risk associated with chemical leakage, hot battery surface and battery rupture:
• Use only same type AA alkaline batteries in presentation pen.
• Avoid fire and heat sources above 100 C.
• Do not short circuit batteries.
• Do not attempt to recharge batteries.
• Do not break or disassemble batteries.
• Avoid eye and skin contact, ingestion and inhalation of battery chemicals in the event of a ruptured or broken
battery.
• Replace all batteries at same time.
• Properly orient the plus (+) and minus (-) terminals of batteries.
• Remove batteries when not used for an extended period of time.