![background image](http://html1.mh-extra.com/html/3m/chassistouch-15/chassistouch-15_users-installation-manual_442656013.webp)
3M Touch Systems Proprietary Information
CHAPTER 2
Setting Up Your ChassisTouch FPD
Monitor
This chapter describes how to set up and integrate your 3M Touch
Systems ChassisTouch FPD monitor into a touch application. You need
to complete the following tasks:
•
Unpack the components
•
Connect the video, touch screen, and power cables
•
Power on the monitor and test your setup
•
Install the touch screen software
•
Calibrate the touch screen
System Requirements
The ChassisTouch flat-panel touch monitors require a personal
computer (PC). These touch monitors are not supported on Macintosh
computers.
The requirements for your PC are as follows:
•
Your PC must have an available RS-232 serial communication (COM) port.
You connect the touch screen to this port.
•
Your PC must have a unique interrupt request (IRQ) available to the COM
port that the touch screen will use. The touch screen cannot share an IRQ
with another device.
•
If the only serial port available on your PC has 25 pins, you will need a 9-pin
to 25-pin adapter.
•
Your PC must have a video card and video driver already installed for the
monitor. If you need to install a video card or a video driver, refer to your
computer documentation for instructions.