2.0 Installation and Assembly of 3M
™
Static Control Anti-Fatigue Mat
Runner 9910
WARNING
To reduce the risk associated with hazardous voltage due to 3M™ Anti-Fatigue Mats
9900 Series being used in areas
requiring insulating type matting:
• M 9900 Series Mats are electrically conductive -- do not use this matting in areas with possible exposure to high
voltage.
To reduce the risk associated with hazardous voltage due to 9900 Series Mats being installed with an
incorrect grounding lead:
• Do not use M 9900 Series Mats without correct grounding cord, M™ Ground Cord 040.
To reduce the risk associated with hazardous voltage due to 9900 Series Mats being grounded through an
alternate ground path:
•
Grounded equipment or objects should not contact the mat. This could bypass the 1.0 M
Ω
resistor in the ground
cord.
To reduce the risk associated with back strain due to the heavy weight of the mats:
• Follow safe lifting procedures during installation or moving.
1. Pre-clean the floor area where the mat runner is to be installed.
2. Before assembling the runner, lay out each mat section in the appropriate sequence. Sequence numbers
can be found on the back of each section along the molded rubber edge. Match the numbers so the
number on one section is next to the same number on the next section. (Figures 1 - 3)
Fig.1
Fig.
Fig.
3. Move the end section of the runner with connector tabs into the desired positioned with the tubular cells
against the floor surface. Place the next runner section in position according to its sequence number.
Proceed in like manner placing each runner section in position according to the numbering sequence until
the whole runner is laid out unconnected on the floor. (Figure 4)
Fig.4