3M 9310 Dust / Mist Respirator
Standard: EN149
Type: FFP1S
Maximum Usage Levels:
4 x WEL* for Particulates**
Approval: CE marked
* Workplace Exposure Limit
**Assigned Protection Factor (APF) as detailed in BS4275: 1997
This respirator should not be used in oxygen deficient environments, for escape
purposes or by people with beards/ facial hair or in atmospheres where
concentrations of contaminant may exceed that deemed Immediately Dangerous
to Life and Health (IDLH)
3M
™
9310 Dust / Mist
Respirator
3 M
™
9 3 1 0 P r e m i u m D u s t R e s p i r a t o r F i t t i n g I n s t r u c t i o n s
3M Health & Safety Helpline Telephone: 0870 60 800 60 For callers within the Republic of Ireland: 1 800 320 500
www.3M.com/uk/ohes
5. Using both hands,
mould noseclip to
the shape of the
lower part of the
nose.
DO NOT pinch the
nosepiece using only
one hand as this may
result in less
effective respirator
performance.
6.
The seal of the
respirator on the face
should be fit-checked
prior to wearing in the
work area
.
1. Noseclip is
located in top panel.
Preform noseclip by
gently bending at
centre
Hold respirator in
hand and pull out
bottom panel to form
cup.
2. Turn respirator
over to expose
headbands.
3. Cup respirator
under chin. Ensure
the two straps are
seperated and pull
the straps over the
head.
4. Locate the lower
strap below the ears
and the upper strap
accross the crown of
the head. Adjust top
and bottom panels
for a comfortable fit.
To check the fit of an
unvalved respirator:
a) Cover the front of the
respirator with both
hands being careful
not to disturb the
position of the
respirator.
b) Exhale sharply. If air
flows around the nose,
readjust the nosepiece
as described in step 5.
If air leaks at the
respirator edges, work
the straps back along
the sides of the head.
If you cannot achieve a proper fit
do not enter contaminated area.
See your supervisor.
1
2
3
4
5
6
3
CH9310 FP 05/06
