5
1B
.
AC/DC Adapter
Connect the AC/DC adapter to the jack at the base of the unit.
Plug the adapter into a 120 Vac outlet.
2.
Battery Indicator
Jack Cover
3.
Insert the plastic cover into the yellow wrist strap plug-in jack that is not
being used. The jack on the right fits standard banana plugs used in
North America. The 746 Wrist Strap Tester is now ready for use.
Wall Mounting
4.
The enclosed 3M™ Dual Lock™ Wall Mounting System adhesion
discs must be screwed onto the wall, using the attached template,
approximately 1,5 m (5 ft.) off the floor. Drill three holes of 5 mm
(0.2 in.) diameter at marked locations.
5.
The enclosed Dual Lock adhesion strip must be cut in two halves and
adhered to the rear of the 746 Tester, parallel to the bottom edge and
below the battery compartment. Make sure the area on the 746 Tester
where the adhesion strips are to be placed is free of dust and dirt.
Press the back of the case firmly against the discs to secure the tester
to the wall.
6.
For removal, lift the 746 Wrist Strap Tester at the two top corners with
both hands.
CAUTION
If the AC/DC adapter is plugged into the 746 Wrist Strap Tester, it must
also be plugged into the wall outlet to allow the unit to function. If the
746 tester is powered with the battery only, the AC/DC adapter MUST
be disconnected from the DC input jack (1B) on the tester.
CAUTION
When operating on battery power only, replace the battery immediately
when the “Battery” indicator LED illuminates.
