4
Specifications
Base unit:
158 x 95 x 33 mm (6.25 x 3.75 x 1.25 in.)
Weight:
200g (7 oz.) without battery
Battery provided:
9 Vdc Lithium/Manganese Dioxide NEDA 1604LC
AC/DC Adapter:
9 Vdc regulated 75 mA
Accuracy:
+/- 10% (10 M
Ω
limit)
+ 20%-0% (750 K
Ω
limit)
Measurement voltage:
19 Vdc +/- 1 Vdc (open circuit)
Environmental Operating Conditions:
Temperature:
Maximum
104° F / 40° C
Minimum
32° F / 0° C
Humidity:
Maximum
80% R.H.
Installation
THE PARAGRAPH NUMBERS BELOW ARE
REFERENCED ON THE DIAGRAM ON PAGE 7.
Power Sources
1A.
9 volt backup battery
Due to the slightly larger size of the long-life lithium battery, it is
necessary to properly locate the battery snap connector and wires in the
battery compartment. To correctly install the battery, follow these
instructions:
Attach the battery snap connector to the battery. Place the battery into
the compartment, locating the snap connector at the opposite end of the
compartment from where the battery wires come through the housing,
keeping the wires along the top edge of the compartment. Run the
battery wires along the side of the battery and tuck them down between
the housing and the battery so that the wires clear the cover. Use a
small, straight blade screwdriver to gently push the battery wires down
below the lip of the compartment. Slide and lock the cover into place.
When changing the battery, the battery cover must be removed
carefully. To remove the battery cover, slide back the cover slightly.
Insert a small, straight blade screwdriver into the opening immediately
over the tab area beneath the word “OPEN.” Press down with the
screwdriver while sliding the cover off. You must use a screwdriver
to remove the battery cover.
