4.1 Check to be sure cable size fits within the kit range as shown in Table 1, page 3.
• Remove cable jacket for 8
1
⁄
4
" (210 mm).
4.2 Cut-off shield wires, leaving 1
1
⁄
4
" (32 mm) exposed beyond cable jacket.
• Remove semi-con (insulation shield), leaving 2
3
⁄
8
" (60 mm) beyond cable jacket.
• Remove cable insulation for 2
1
⁄
8
" (54 mm).
• Place a
1
⁄
8
" (3 mm) bevel on end of cable insulation, to ease installation.
4.3 Remove white liners from one mastic strip and apply one wrap around cable jacket
1
⁄
2
" (13 mm) from edge. Apply
with light tension. Cut off excess mastic.
• Position preformed ground braid with long leg along cable jacket as shown, with braid solder block centered on
previously applied mastic strip.
• Wrap short leg of ground braid around cable wire shield for one complete wrap. Trim excess to eliminate overlap.
4.4 Secure ground braid to wire shield with constant force spring. Wrap spring in same direction as ground braid, as
shown. Cinch (tighten) the last wrap of spring.
• Remove liners from second mastic strip and apply one wrap over solder block and previously applied mastic strip.
Cut off excess mastic.
• Apply two half-lapped layers of vinyl tape over mastic, constant force spring and exposed wire shield.
4.0 Preparation of Wire Shield Cable
4.1
4.2
4.3
4.4
5
78-8124-4544-9-B
;
;
y
y
;
;
y
y
;;
;;
yy
yy
;;
;;
yy
yy
;;
;;
yy
yy
Summary of Contents for 5811 Series
Page 11: ...11 78 8124 4544 9 B ...
