Figure 2
IMPORTANT INSTALLATION INSTRUCTIONS
1. Shut off main water supply. Drain water from water lines by opening faucet downstream of install location.
2. Cut pipe to length needed to install filter head and recommended bypass.
3. Assemble filter head and bypass system as shown in Figure 2. Use three ball valves and one filter head as shown.
Use common pipe and connections to assemble system.
4. Use supplied bracket or pipe hangers to support the system.
5. Install replacement filter into filter head by following replacement filter instructions as shown on next page.
6. Open main water supply slowly to pressurize system and check for leaks.
7. Close bypass valve and open faucet to flush no less than 10 gallons (approximately 15 minutes) through system before use.
Plumbing Assembly of Bypass and Filtration System
Valve #1
Valve #1
Valve #2
Valve #2
Valve #3
Valve #3
