International - ENG
February 2021
3M-Matic
™
7000a-I / 7000a3-I Pro - Type 11700 Original Instruction
Page 26
Source
Document
for
all
related
Manuals/Translations
44-0009-2164-1 / ECO# 0078045
Note:
Loosen
but do not
Remove
Column
Screws
B
Figure 11-5
Figure 11-6
Figure 11-4
Figure 11-7
B
11.5 Special Set-Up Procedure for Outer Column Re-Positioning
(
continued
on next page)
Moving the outer columns will increase/decrease the maximum box height capacity of the
7000a-I / 7000a3-I Pro
case sealer.
1. Place solid blocks approximately 12” [305mm] high at front and rear of upper taping
head assembly as shown in
Figure 11-7A
.
2. Crank the upper taping head assembly down until it touches these blocks.
3. Loosen (but do not remove) the four (4) screws and washers that fasten each column to
the
frame
(Figure 11-7B).
Note:
You may also need to loosen the two set screws in the nut plate bracket
(located above bottom two column screws).
(
continued
on next page)
A
A
11. Set-Up and Adjustments
(continued)
