3M 3M Matic 120af, Instructions And Parts List

Page: 17 / 82

12
9.Remove fasteners that secure case sealer legs
to pallet.
Use appropriate material handling equipment to
remove the machine from the pallet and move it
into position.
Whenever the machine is lifted with a fork truck,
insure that the forks span completely across the
machine frame and do not contact any wiring or
mechanism under the machine frame. Remove
lower taping head by lifting head straight up
out of machine bed. Also make certain to have
one side of the fork on each side of the vertical
column and electrical control box as shown in
Figure 2-3.
CAUTION – Machine weighs
approximately 250 kg [545 lbs]
uncrated.
Installation and Set-Up
(Continued)
Figure 2-1 – Machine Set-Up
Refer to Figure 2-2A and set the machine bed
height as follows:
a.Use appropriate material handling
equipment and blocking techniques to raise
the machine frame to allow adequate leg
adjustment.
b.Loosen, but do not remove, two M8 x 16
socket head screws in one leg (use M6 hex
wrench). Adjust the leg length for the
desired machine bed height. Retighten the
two screws to secure the leg. Adjust all four
legs equally.
10.Adjust machine bed height. The case sealer is
equipped with four adjustable legs that are
located at the corners of the machine frame.
The legs can be adjusted to obtain different
machine bed heights from 585 mm [23 inch]
minimum to 715 mm [28-1/8 inch] maximum.