Manuclave Anchor Clamp
User Instructions
Product Warranty, Limited Remedy, and
Limitation of Liability
WARRANTY:
THE FOLLOWING IS MADE IN LIEU OF ALL WARRANTIES OR CONDITIONS, EXPRESS OR
IMPLIED, INCLUDING THE IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE. Equipment offered by 3M is warranted against factory defects in workmanship and materials for
a period of one year from date of installation or fi rst use by the original owner.
LIMITED REMEDY:
Upon notice in writing, 3M will promptly repair or replace all defective items. 3M reserves the right to
elect to have defective item returned to its plant for inspection before making a repair or replacement. Warranty does not cover
equipment damage resulting from wear, abuse, damage in transit, or other damage beyond the control of 3M. 3M shall be the
sole judge of product condition and warranty options. This warranty applies only to original purchaser and is the only warranty
applicable to our products. A
Return Goods Authorization Number (RGA)
must be issued by 3M on all returns for warranty
consideration. All returns must be shipped to 3M freight prepaid. Please contact 3M customer service department at
1-800-560-1094 for warranty assistance.
LIMITATION OF LIABILITY:
In no event will 3M be liable for any indirect, incidental, special or consequential damages
including, but not limited to loss of profi ts, in any way related to the products regardless of the legal theory asserted.
Please recycle. Printed in USA.
© 2010
3M is a trademark of 3M Company,
used under license in Canada.
All rights reserved.
IM-0028 Rev A 12-2010
3M Occupational Health &
Environmental Safety Division
4551 Raceway Drive SW
Concord, NC 28027
USA
Phone 1-800-560-1094
Fax 1-800-560-1275
www.SafeWaze.com
www.3M.com/OccSafety
Installation
The Manuclave Anchor Clamp must be installed on structures
capable of meeting the anchorage strength requirements of
OSHA 29 CFR 1910.66 and 1926.502.
Squeeze handle together to open the top section of the
Manuclave Anchor Clamp and slip over structure. Rotate
handle to allow the circular part of clamp to position itself
around the structure. Release the handle to allow the hooks to
engage on each side.
Do not use the Manuclave Anchor Clamp on angled
structures, or at the end of a run where it could slide off the
end of the structure.
Do not use the Manuclave Anchor Clamp where loading is
offset to the center of the Manuclave Anchor Clamp.
Inspection
All Manuclave Anchor Clamps must be inspected prior to
each use, and additionally by an OSHA defi ned competent
person other than the user annually.
Any equipment that has been subjected to the forces of
arresting a fall must be removed from service.
All Manuclave Anchor Clamps must be free of cracks, sharp
edges, deformation, corrosion, chemical attack, alteration,
excessive heating or wear.
All markings must be legible and attached to the product.
If inspection reveals any defect, inadequate maintenance, or
unsafe condition, remove from service and destroy.
Note: Only manufacturer, or entities authorized in
writing by the manufacturer, may make repairs to the
product.
Cleaning and Maintenance
No cleaning or maintenance is required for this product.
If inspection reveals any defect, remove from service and
destroy.
