http://www.3jtech.com.tw
http://www.pnpipcameras.com
FWT WIFI AP_USB x 4 User’s Guide
Copyright of 3JTech Co., Ltd. (also doing business as A3J Engineering Inc.)
53
In the case of sending the facsimile from the FWT to PSTN line:
1) Connect a fax machine to the phone jack of your FWT Wifi AP_USB x 4 using a RJ-11 cable.
Make sure the SIM card, U6100 module and antenna has been installed on your router.
2) Power on the fax machine and your FWT Wifi AP_USB x 4.
3) Wait for dial tone on the fax handset. The router is ready when you hear the dial tone.
4) Insert pages you would like to send into the fax machine.
5) Dial the command of
*329#destination Fax number#
on the fax machine connected to the
FWT Wifi AP_USB x 4. Wait to hear a long ring.
Note: Area code needs to be added when dialing the destination Fax number if your destination PSTN line is
located in different city/county.
6) Immediately, you will hear the fax modem sound after long ring. Press the "
Send
" button on
your fax machine.
7) Wait for the transmission to complete. At the end, the fax machine will display "page sent" or
"error" message. It will print out the report in case any error occurs.
In the case of sending the facsimile from PSTN line to the FWT:
1) Connect the PSTN line to the fax machine.
2) Power on the fax machine and insert pages you would like to send into the fax machine.
3) Contact our 3Jtech to request the server’s fax number, and dial this number on the fax
machine connected with the PSTN line.
4) Just follow the voice instructions you had heard, then dial the command
destination FWT
number#
on the fax machine connected with the PSTN line.
About the FWT number, you can
refer to Section 3.4.5.2.
Note: Area code needs to be added when dialing the fax number of the server if your city/county is different
from the one in which 3Jtech’s fax sever is located.
5) Press the "
Send
" button on your fax machine.
6) Wait for the transmission to complete. At the end, the fax machine will display "page sent" or
"error" message. It will print out the report in case any error occurs.
