background image

Ver 1.0.0.0 

 

Since 1988 

 

3. LED Description of the Rear Panel 

 

 

 

 

 

 

 

 

LED 

Color 

Status 

 POWER(

)

 

Yellow  Lit when +12V DC power is on and working. 

 SMS(

Yellow 

Lit when receiving any new SMS(s). 

Off at any status except the incoming of new SMS(s).

 

WLAN(Wireless LAN

)

 

Yellow 

Lit when the WiFi function is enabled. 

Flash when the data is transmitting.                 

Off when the WiFi function is disabled.              

 LAN Link(

Yellow 

Lit when the cable connection with device exists. 

Flash when the data is transmitting.                 

Off when no cable connection exists. 

 

WAN Link(

)

 

Yellow 

Lit when the cable connection with device exists. 

Flash when the data is transmitting.                 

Off when no cable connection exists. 

  Pick Up/Hang Up (

)

 

Yellow 

Lit when picking up the connected analog phone.   

Off when hanging up the connected analog phone. 

 

3G PPP Status (

Yellow 

Lit when dialup is connected. 

Flash when the data is transmitting.                 

Off when dialup is disconnected.                  

3 Cellular Signal Strength LEDs

 

Low (

 

Yellow 

All 3 LEDs lit when the signal strength is good.     

(The LEDs lit would decrease progressively upon the 

signal strength) 

Medium (

High (

Summary of Contents for FWT Wifi AP

Page 1: ...RJ 45 cable 2 Make sure the SIM card has inserted to the modem and the modem is ready as well 3 Connect XDSL Cable to the WAN port of your FWT Wifi AP_USB x 4 using a RJ 45 cable if needed 4 Sequentially plug the external 3G USB dongle s into the USB connector on your FWT Wifi AP_USB x 4 for the load balance with multiple 3G For example if you own single USB dongle it must be connected to USB 1 po...

Page 2: ...e exists Flash when the data is transmitting Off when no cable connection exists WAN Link Yellow Lit when the cable connection with device exists Flash when the data is transmitting Off when no cable connection exists Pick Up Hang Up Yellow Lit when picking up the connected analog phone Off when hanging up the connected analog phone 3G PPP Status Yellow Lit when dialup is connected Flash when the ...

Page 3: ...me and the password Click OK button to enter AP s setup page 4 Once you are in the setup page please select Internet Settings and enter WAN section of the setup 5 In the WAN MODE SETTINGS please select the desired WAN connection type and require the necessary information from your ISP once the STEP 3 in Section 2 is configured 6 As to 2G 3G ISP SETTINGS please also contact your ISP for the dialup ...

Page 4: ...the Management Status function The information should be displayed under the Internet Configurations section 5 Restore Factory Default Settings FWT Wifi AP_USB x 4 provides a RESET button that will be easy for users to reset the AP to default The button is located at the front panel of the AP See the figure below Reset steps are as follows 1 Press the RESET button 2 seconds around 2 All LEDs on th...

Reviews: