22
To connect Wi-F
i antenna to Pegasus™ NX
1.
Open the
Pegasus™ NX front panel
.
2.
On the PCB, connect the
u.FL adapter
to the
u.FL/IPX connector
as shown in image B.
3.
Connect the
RP-SMA Wi-Fi antenna
to the
RP-SMA connector
(part of the pigtail cable).
Note:
Figure B is for demonstration purpose only. Here, the Pegasus NX rear panel is not visible, but in actual
condition only the thread of RP-SMA Wi-Fi adapter (part of the pigtail cable) is available through a hole in the
left-side of the Pegasus™ NX rear panel. Securing the Wi-Fi antenna on the RP-SMA adapter can be done in
the same way as demonstrated in figure B above.
Summary of Contents for Pegasus NX
