12
3. Under Install Hardware Device Drivers, click “Search for a suitable driver for my device
(recommended),” then click Next.
4. Under Locate Driver Files, make sure the appropriate search location is selected, and that
Disk 1 of the driver media is loaded in the appropriate drive; then, click Next. The
Wizard locates the driver installation files.
5. Under Driver Files Search Results, click Next to start the installation.
6. Insert Disk 2 when prompted, then click OK to continue with the installation.
7. Once the driver successfully installs, click Finish to dismiss the Found New Hardware
Wizard.
8. When told that the workstation must be restarted for the new settings to take effect,
remove the delivery media from the disk drive (if applicable) and click Yes to restart the
workstation.
NOTE:
See “Configuring the Video Display in Windows 2000” later in this document for instructions on
setting the display properties.
Verify the Default Video Display Driver
If you’re running Windows NT 4.0
To verify the default video display driver:
1. From the operating system Start menu, go to Settings/Control Panel/Display, and click
the Settings tab on the Display Properties dialog box.
2. Click Display Type, then verify that 3Dlabs Wildcat 4110 PRO is listed under Display.
This indicates that the appropriate driver is installed.
3. Click Cancel to close the Display Properties dialog box.
If you’re running Windows 2000
To verify the default video display driver:
1. From the operating system Start menu, go to Settings/Control Panel/Display, and click
the Settings tab on the Display Properties dialog box.
2. Verify that two 3Dlabs Wildcat 4110 PRO devices are listed under Display. This
indicates that the appropriate driver is installed.
3. Click Cancel to close the Display Properties dialog box.
Summary of Contents for The Wildcat 4110 PRO
Page 22: ...16 Figure 5 Wildcat 4110 PRO Stereo Output Port ...
Page 23: ...17 ...
Page 34: ...30 ...
