page
22
... print your plane | www.
3DLabPrint
.com
fuselage_01
Start with motor mount (fuselage 1)
We suggest to anneal the PLA motor mount. You can use this procedure: submerge in boiling
water, heat it in owen or
a lid on your heatbed and heat it up to 100°C
for more than 30 minutes.
Because PLA shrinks when annealed (about 2%) it is good idea to use EDGE_73_
fuselage_01_annealing compensated for this effect, you can adjust scale exactly for your PLA
brand in Simplify3D or any next slicer:
Proceed the way shown in videoguide:
Glue the fuselage parts F1-F9 with CA glue together
.
You can use snap knife to clear the
shape of printed parts, but mostly this is not necessary.
Glue the „sure bonds“ (small triangle parts) to the slotes in fuselage (F1-F5 parts):
Apply CA glue to the contact surfaces
F1 part (marked red in the picture) and
atach them together:
Simulatenously screw in four self-
tapping screws, then apply CA
activator:
