3D Systems sPro, User Manual

Page: 202 / 280

SLS p r o c e s s 2 0 2 S L S S Y S T E M
u s e r ’ s g u i d e S L S s y s t e m t r o u b l e s h o o t i n g
S L S Sys t e m Tr o u b l e s h o o t i n g
SLS system Stacklight states
Your SLS System has a Stacklight, a pole with four
colored lights on it that can turn on or flash to
indicate the states of the machine:
L
The red and yellow
lights will both be
lit if a warning and
alarm are active at
the same time.
SLS System Failure Modes
If you are having problems with your SLS system,
refer to the table of SLS system failure modes
below.
COLOR MODE SLS SYSTEM STATUS
Red
Off Normal
Steady An alarm is active.
Yellow
Off Normal
Steady A warning is active
Flashing
Safety override during
service by a Field Engineer.
Green
Off
SLS system is powered off or
not ready.
Steady
Normal. SLS system is okay;
operating normally
Blue not used
See Using the
Stacklight in Sinter
Help for Stacklight
testing instructions.
To prevent injury and equipment
damage, do not attempt to perform
any corrective action labeled
3D CSE Only in the table below.
Any correction labeled 3D CSE Only
in the table below must only be
performed by a 3D Systems Customer
Support Engineer (3D CSE) or
Authorized Service Representative.