ProJet
®
x60
Pro
Series User Guide
Setup And Print The Build
3dscentral.3dsystems.com
21
All Rights Reserved
5/12/13
After the bulk of the Core is removed from the Build Bed, gently pick up the part and place it in the Core
Recycling Unit (160 and 260C) or built-in Post-Processing Unit (360 and 460
Plus
) where you can clean the
part of any remaining Core with the Air Wand.
1.
Open the printer top cover.
2.
Ensure that the Fast Axis is pushed all the way back into its parked position.
3.
Select
BUILD CHAMBER > RAISE PLATFORM
on the LCD menu. Hold the Control Knob down to
raise the platform closer to the top of the Build Bed.
4.
Gently lift the part and place it in the Core Recycling Unit or Post-Processing Unit.
2.8.3 Using the Removable Build Plate
The ProJet 160 and ProJet 260C feature a removable Build Plate, which allows you to pick up the entire
Build Plate and use it as a tray to transport very delicate parts to the Core Recycling Unit.
To remove the Build Plate follow the steps below.
1.
Open the printer top cover.
2.
Ensure that the Fast Axis is pushed all the way back into its parked position.
3.
Following the steps in the Coarse Cleaning section, vacuum as much Core as you can from around the
part.
4.
From the Main Menu on the LCD, select
ACCESS BUILD PLATE
on the LCD menu. The Build Plat-
form will move up above the top of the Build Box, exposing the Build Plate.
Number
Component
1
Build Plate (in raised position)
2
Front Overflow
3
Service Station