extruders 1 and 3.
CAUTION: There should be enough access to reach the torx screws using an
insulated torx driver. Exercise caution when working around the PCBs.
NOTE: Print jet 2 should not need further adjustment.
Connect the printer to utility power, turn on the main power switch and then turn on
37.
the display.
Navigate to the
Print Plate Calibration
screen and select
MOVE JETS
.
38.
Select the
Z: down arrow
until the display reads -0.50.
39.
NOTE: Visually inspect the gap between the nozzle tip of print jet 2 and the
print pad. If necessary, press the Z: down arrow until there is a gap.
Summary of Contents for CubePro
